For removing bearings, gears, discs, etc. for tight or difficult-to-access spaces., leg length 100mm maximum pulling diameter 120mm
Description
Thin pulling hook with quick adjusting capability quick adjust.
Parallel pulling hooks in every position, even with full load.
Pulling hooks with infinitely variable adjustment on the cross-beam.
Optimal adjustment of the spindle to the shaft with 2-sided spindle tip (ball and tip).
Mechanical pressure screw.
Milled thread treated with special coating.
The three-arm design ensures that the load is distributed evenly and that the part to be removed is held securely.
If there is not adequate free space around the part to be removed, we recommend using a 2-jaw puller series 20+S for optimal force distribution.
Advantage
The thin pulling hooks are suitable for narrow, difficult-to-access locations.
A manual adjustment knurl allows rapid loosening and adjusting of the extractor jaws on the cross-beam without using a wrench.
Can be installed on various pulling hooks and variable reach thanks to jaw extensions.
Turning the pulling hooks enables them to be used both internally and externally.
Suitable for pulling asymmetric workpieces.
Spindle head band prevents the wrench from slipping off.
Almost all components available as replacement parts, time-saving order process thanks to numbering system.
Note: Pressure pads from series 600-17 are a good addition if the shaft is hollow and the spindle cannot be supported.
How it works
The part due to be removed (e.g. a gear, pulley or ball bearing) is gripped from the outside. Tightening of the pressure screw and the resulting pressure removes the part from the shaft.
The puller must be positioned centrally for centre shafts. If the shaft is not sitting centrally, the parts can be removed asymmetrically with pullers with parallel pulling hooks.
Spare part
614135 Mechanical pressure spindle.
1-93-S 3 narrow, quick adjusting jaws (set)
30-10-T Cross-beam
Also included in
K-2030-10+S Universal 2-jaw and 3-jaw puller set with narrow, quick-adjusting pulling jaws
Accessories
1-93-S 3 narrow, quick adjusting jaws (set)
1-193-S 3 narrow, quick adjusting jaws (set)
1-253-S 3 narrow, quick adjusting jaws (set)
1-95-S 3 extremely narrow, quick adjusting jaws (set)
1-195-S 3 extremely narrow, quick adjusting jaws (set)
1-255-S 3 extremely narrow, quick adjusting jaws (set)
Safety information
The pulling hooks' sliding parts must always sit stably and fully on the cross-beam.
If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
The pulling hooks' support surfaces must always be straight and sit fully beneath the part to be removed.
Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
Protective blanket required.
Protective goggles required.