If you still can't find the part you need, contact us and we'll do all we can to locate it - just give us a call:
+44 (0)1709 527 269
For use with Series 21, Series 21-E orSeries 22 -1-AS.
Description
The arms of the counter supports can be easily adjusted by an internal suspension (size 1 to 3).
The frictional resistance of the counter support nut is reduced to a minimum by a built-in thrust bearing.
The counter supports of sizes (4 and 5) are particularly suitable for large ball bearings etc. with their support feet and ensure a firm footing when pulling out.
Mechanical spindle.
Advantage
The counter support can be combined with internal extractors and threaded adapters of the Kukko brand.
Almost all components available as spare parts, time-saving ordering by numbering.
Working Method
Screw the internal extractor or the threaded insert into the component.
To remove, screw the spindle of the counter support onto the internal extractor or threaded pin.
The arms of the counter support must not block the part to be extended, and it must be ensured that the arms are aligned in parallel.
Hold the T-handle and at the same time tighten the nut evenly above the cross-bar with an open-end wrench until the component is released from its seat.
Is Required By
21-6 2-shell interior extractor
21-7 2-shell interior extractor
21-8 2-shell interior extractor
21-9 2-shell interior extractor
22-1-AS Threaded insert set
Safety Notice
Do not use electric or pneumatic power or impact wrenches.
Safety cover required.
Wear safety glasses.
Bulk Order or Trade Enquiry? Contact us or give us a call on +44 (0)1709 527 269