The perfect tool for pulling out ball bearings, ball bearing races, sleeves and bushes, puller length 54mm pulling diameter 4.8mm - 6.5mm. For extracting bearings, bearing outer rings and bushings that lay flat on one another.
The segmented design with extra fine grasp edges ensures safe extraction.
Mechanical pressure screw.
Kukko internal extractors can be combined with counter supports and slide hammers.
Almost all components available as replacement parts, time-saving order process thanks to numbering system.
How it works
Place the internal extractor into the bearing's hole.
Using a ring spanner, tighten the nuts to open the jaws of the internal extractor. Make sure that the jaws sit securely below the bearing's inner race.
For removal, the spindle on the counter support series 22 or on the slide hammer series 22-0 is screwed onto the key spindle on the internal extractor.
2. The counter support's arms must not block the part due to be removed. Make sure that the arms are parallel.
3. Hold on to the T-grip and at the same time use the jaw wrench to tighten the nuts above the cross-beam until the component has been loosened from its position.
2. The part is extracted by using the slide hammer to exert powerful force until the component has been loosened from its position.
Puller length: 54mm
Min pulling dia: 4.8mm
Max pulling dia: 6.5mm
Suitable for Kukko counterstay part no: 22-1, 22-2
Suitable for Kukko slide hammer part no: 22-0, 22-0-1
KUKKO - The name for pullers