For removing particularly tight ball bearings, bearing rings and workpieces. Leg length 90mm, max pulling dia 80mm
With integrated clamp.
Mechanical pressure screw.
Milled thread treated with special coating.
Clamps increase the pressure of the hooks significantly.
Spindle head band prevents the wrench from slipping off.
Safe, fast and efficient disassembly.
Almost all components available as replacement parts, time-saving order process thanks to numbering system.
Note: Pressure pads from series 600-17 are a good addition if the shaft is hollow and the spindle cannot be supported.
How it works
The part due to be removed is gripped from the outside.
Tighten the clamps to press the hooks around the workpiece.
Tightening of the pressure screw and the resulting pressure removes the part from the shaft.
Note: Make sure that the clamps have been tightened during the process.
618105 Mechanical pressure spindle.
204201 Complete clamp
204-1-90-P 2 pulling jaws (pair)
204101 Complete clamp
Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
Protective goggles required.