If you still can't find the part you need, contact us and we'll do all we can to locate it - just give us a call:
+44 (0)1709 527 269
For removing ball bearings, roller bearings, inner races and other tight parts if there is not enough space to use pulling hooks. Min pulling dia 5mm, max pulling dia 60mm
Description
Optimal adjustment of the spindle to the shaft with 2-sided spindle tip (ball and tip).
With quick-clamping pressure spindle.
The sharp blades enable flush parts to be removed where pulling jaws cannot be used.
The wedge-shaped separator jaws are secured underneath the component to be removed.
The large supporting surfaces protect the parts to be pulled.
Advantage
Easy to use, as the separator jaws are quickly and centrally tensioned with just one pressure spindle.
Ultimate stability when removing, as the separator and pulling device are screwed firmly together.
Almost all components available as replacement parts, time-saving order process thanks to numbering system.
Has to be accomplished with
18-0 Pulling device
How it works
The wedge-shaped separator jaws are secured underneath the component to be removed.
Separate the part by tightening the quick clamping pressure spindle.
The flat surfaces of the separator blades are used to remove sensitive parts without damaging them. The separator blades provide a larger supporting surface to prevent the parts from twisting.
For removal, the tension bolts on the pulling device series 18 have to be screwed into the separator.
The part is removed by tightening the spindle against the end of the shaft.
Spare part
17-0-T Cross-beam
17-0-06 Spindle
017140 Side bolt complete
Part of
17-K Separating-set with quick clamping pressure spindle
EVLW-1-INDUSTRIE Display
Spare part of
17-K Separating-set with quick clamping pressure spindle
Safety information
If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
The separator blades' support surfaces must always sit fully beneath the part to be removed.
Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
Protective blanket required.
Protective goggles required.
Bulk Order or Trade Enquiry? Contact us or give us a call on +44 (0)1709 527 269