If you still can't find the part you need, contact us and we'll do all we can to locate it - just give us a call:
+44 (0)1709 527 269
For removing ball bearings, roller bearings, inner rings and other flush mounted parts, if there is not enough space for the jaws.
Description
4-piece set, each with a separating and pulling device and a pair of extensions.
The sharp blades allow the removal of flush-mounted parts where jaws are inapplicable.
The wedge-shaped separating jaws are fixed under the component to be removed.
The large contact surfaces protect the part to be removed.
Operating instructions in the lid.
Safe storage in special foam.
Personal KUKKO chip code.
Advantage
Highest stability when peeling, as the separator and extractor are firmly screwed together.
Practical composition for universal use.
Completeness at a glance manageable.
Almost all components available as spare parts, time-saving ordering by numbering.
Kit in the proven KUKKO-i-Boxx system.
Consists of
15-1 separating device
18-1 puller
19-1-P 2 extensions for pullers (pair)
Working Method
The wedge-shaped separating jaws are fixed under the component to be removed.
The clamping of the separating jaws takes place by uniform tightening of the nuts on the side bolts.
For gentle removal of sensitive parts, the flat surfaces of the cutting blades are used. This results in a large contact surface, which prevents tilting.
To pull off the draw bolts of the puller must be screwed into the separator.
Note: The depth of cut can be increased with the extensions included in the set.
The removal takes place by tightening the spindle against the shaft end.
Safety Notice
For several parts to be removed, always remove gradually. Never remove several parts at the same time.
The contact surfaces of the cutting knife must sit completely under the part to be peeled off.
Do not use electric or pneumatic power or impact wrenches.
Safety cover required.
Wear safety glasses.
Bulk Order or Trade Enquiry? Contact us or give us a call on +44 (0)1709 527 269