Telephone: +44 (0)1709 527 269
Opening Hours: Monday to Friday (8.30am - 5.00pm)
Search

Reference Code


Search by size

mm
mm
mm

Use metric measurements only. See conversion chart.


Still can't find the part?

If you still can't find the part you need, contact us and we'll do all we can to locate it - just give us a call:
+44 (0)1709 527 269


Browse by category...

1108-14 Taper Bush 14mm Bore

1108-14 Taper Bush 14mm Bore
1108-14 Taper In Stock
£2.50£3.00 inc. VATGBP £ | EUR € | USD $
x

Taper bush suitable for pulleys and sprockets 14mm Bore

Taper bushes are the most convenient and cost effective method of fixing components to a mating shaft without using any special tools

Bore dia: 14mm
Keyway width: 5mm
Keyway depth: 2.3mm
Shallow keyway depth: -

Screw tightening torque (Nm): 5.6
Screw size (BSW): 1/4 inch, hex, socket size: 3mm

Large end dia: 38.0mm
Bush length: 22.3mm

Mass: 0.1kg

To Install:
1. Clean shaft, bore and outside of bush, and bore of hub. Remove any oil, laquer or dirt, Place bush in hub and match half holes to make complete holes (each complete hole will be threaded on one side only).
2. Lightly oil thread and point of set screws, or thread and under head of cap screws. Place screws loosely in holes that are threaded on hub side.
3. Make sure bush is free in hub. slip assembly onto shaft and locate in the desired position.
4. Tighten screws alternately and evenly until all are pulled up tightly
5. Hammer against large end of bush using hammer and block or sleeve to avoid damage. Screws can now be turned a little more to the specified torque setting. repeat this alternate hammering and screw re-tightening until the specified torque is reached. Fill all holes with grease to exclude dirt.

To Remove:
1. Remove all screws. Lightly oil thread and point of set screws, or thread and under head of cap screws.
2. Insert screws into removed holes that are threaded on the bush side. In sizes where washers are found under screw heads, be sure to use the washers.
3. Tighten screws alternately until bush is loosened in the hub and then remove the complete assembly. If bush does not loosen immediately, tap on hub.

1108-14 Taper Bush 14mm Bore image 2

Dimensions - d (inside diameter)14mm

Related categories for 1108-14 Taper Bush 14mm Bore

Other Taper Bushes similar to 1108-14 Taper Bush 14mm Bore

Bulk Order or Trade Enquiry? Contact us or give us a call on +44 (0)1709 527 269

Translate this page
FrançaisFrançais   EspañolEspañol   DeutschDeutsch   ItalianoItaliano   NederlandsNederlands
GBP EUR USD
Currency: GBP
Free UK Shipping German Pulling Tools Deep Groove Bearings Credit Application Form

Read our Privacy Policy Your access to and use of this Website is conditional on your acceptance of these Terms and Conditions of Use (H)
© Bearing King 2019, Unit 5, Stonerow Way, Parkgate, Rotherham, S60 1SG