For removing bearings, gears, discs, etc. for tight or difficult-to-access spaces.
Thin pulling hooks in various lengths.
Pulling hooks with infinitely variable adjustment on the cross-beam.
Pulling hook with sliding part only available in pair of 2.
Variable reach thanks to jaw extensions, available up to a puller size of -30.
Turning the pulling hooks enables them to be used both internally and externally.
Suitable for pulling asymmetric workpieces.
As a replacement part or supplement to your Kukko puller.
Spare part of
K-2030-10-S Set of two- and three-arm pullers with narrow jaws
20-1-S Universal 2-jaw puller with narrow jaws
20-10-S Universal 2-jaw puller with narrow jaws
20-10-SP Universal 2-jaw puller with narrow jaws, in set
Always replace defective pulling hooks in pairs.
The pulling hooks' sliding parts must always sit stably and fully on the cross-beam.
If several parts have to be removed, always follow a step-by-step process. Do not remove several parts at the same time.
The pulling hooks' support surfaces must always be straight and sit fully beneath the part to be removed.
Do not use any electrical or pneumatic servo screwdrivers or hammer drills.
Protective blanket required.
Protective goggles required.